« previous next »
Pages: [1]   Go Down

Author Topic: The End is Nigh...  (Read 5186 times)

Offline Kaile_Bloodhammer

  • Full Member
  • **
  • Posts: 141
  • Karma: +5/-0
The End is Nigh...
« on: July 21, 2009, 04:43:08 PM »
Just thought all of you should know.  We are all totally F'ed!

EATR
Note this artical had to be rewritten to stated that the robot does not eat living or human matter living or dead.

Cyberdine's HAL
Cyberdine sytems creates HAL...What could possibly go wrong?!?!?!

I reitterate we are so F'ed
« Last Edit: July 27, 2009, 08:53:23 AM by Kaile_Bloodhammer »
Logged

Offline dmcgee1

  • Board Member
  • Administrator
  • Member Emeritus
  • *****
  • Posts: 3179
  • Karma: +147/-7
  • Ask away!
Re: The End is Nigh...
« Reply #1 on: July 22, 2009, 02:49:00 PM »
Way to tip 'em off, Shawn!

ADDRESS NOT FOUND
Logged
If sing, sang, and sung, sink, sank, and sunk, and drink, drank, and drunk, how is it that it isn't bring, brang, and brung, think, thank and thunk, and ding, dang, and dung?

Don't even get me started about bad, badder and baddest.  Run, ran AND run...again?  C'mon!

Offline MadBrad

  • Member Emeritus
  • *****
  • Posts: 1128
  • Karma: +52/-0
Re: The End is Nigh...
« Reply #2 on: July 22, 2009, 03:30:32 PM »
As a member of the Board of Directors at Cybertronic, I want to reassure you all that these erroneous reports, belch, have been grossly exagerrated!   

Thank You,

Exective Director
Cybertronic Holdings, LLC
Logged
Cybertronic - Superior by design

E-Bay Handle: bradthemad

Offline Veez

  • Member Emeritus
  • *****
  • Posts: 2990
  • Karma: +159/-7
Re: The End is Nigh...
« Reply #3 on: July 23, 2009, 06:24:48 AM »
++++POTENTIAL INSURGENTS IDENTIFIED AND MARKED BY AI RECOGNIZERS++++
Logged
VeezCon products:  Not as good as if they had been actually produced by a real figure company, but better than using your shoe to proxy with...sort of!
Pages: [1]   Go Up
« previous next »